Bordercollie
Senior Member
You've going to cycle the skeena train sets out of TMC? That's 10k round trip for maintenance. Not to mention 8 days round trip.
|
|
|
- Thread starter ehlow
- Start date
micheal_can
Senior Member
That is one route I am not sure of. However,the other 3 would be more realistic.
Urban Sky
Senior Member
Would you mind continuing this conversation in private messages rather than here, as I recall at least a dozen times where the very same points were explained to the very same commenter?
bearcat
Active Member
I have not been following this thread closely, but does anyone have any idea how much adding "shunt enhancers" will cost per consist, and whether that would definitively resolve the issue with CN?
Trackside_Treasure
Active Member
American figures: The FRA’s Consolidated Rail Infrastructure and Safety Improvements (CRISI) granted $58.8 million to Amtrak to install Onboard Shunt Enhancement devices on 443 locomotives and 192 cab cars to prevent trains from losing shunt, which can cause problems with signal and crossing-gate activation, part of a $2.4B announcement. By my math, $93,000 US per installation.
dowlingm
Senior Member
it seems that grant may have fallen victim (at least a delay) thanks to the change in administration (see last post from May)
Solution to the "shunt" problem?
We are all familiar with the issues with passenger trains not "shunting" signals, leading to Class 1 owners demanding minimum numbers of axles in trains; think CN on Chicago-Carbondale trains and CN (again) with new Siemens Venture trains (there are also examples on UP and, maybe, others). I...
www.amtraktrains.com
Rail labor opposes Amtrak request for waiver to deal with ‘loss of shunt’ until testing data is shared (updated) - Trains
WASHINGTON — Three labor organizations have opposed Amtrak’s request for a waiver allowing installation of a device the company claims will prevent incidents where trains fail to trigger track circuits. As a result, a decades-old issue that recently has forced Amtrak to assign at least seven...
www.trains.com
bearcat
Active Member
So $93,000 per venture set? Multiplied by 32 and converted to CAD that's about $4 millions. That seems like a small amount of money in the grand scheme of things. I wish the federal government just gave this to VIA.
robmausser
Senior Member
How much would adding more train cars to the Ventures cost in comparison? Anyone know a ballpark figure? One comes with the advantage of more seating and the other does not.
cplchanb
Senior Member
Considering the contract for the trains back in 2018 was a $1B, it would prob be a few million each.
Urban Sky
Senior Member
Dividing the total price tag of $989 million by 32 trainsets and then 7 units (assuming that a locomotive is twice as expensive as a car) suggests $4.5 million a car, so maybe a ballpark figure of $5 million is plausible?
bearcat
Active Member
So one car would cost more than adding shunt enhancers to all the Venture sets by my calculation.
cplchanb
Senior Member
Yea a tiny sensor will for sure be cheaper than the whole car
robmausser
Senior Member
smallspy
Senior Member
No - $93k USD x2 per set. One each on the cab car and loco.
And then there's the whole issue that they need to be certified in Canada. It took the US 4 years to certify them there, expect that it will take a similarly ridiculous amount of time here.
Dan
Trackside_Treasure
Active Member
Totally untested technology in Canada and US railway unions are actually against the exemption allowing for the shunt-enhancers? This is not off the shelf technology in either country, and with possible similar union opposition (?) and government red tape (as in the current Ministerial Order) here in Canada, it would be a horserace to see whether more Venture cars could be ordered, built and paid for, or whether shunt-enhancers could be designed, tested and implemented. Perhaps more like a tortoise race now that I think of it!